‘ Grow Up Japan smart drive power flex Supermicro Tyan ENERMAX Coolergiant PC & POWER Cooling Corsair aqua innovatek raptor black noise Highpoint

Grow Up Japan Co,.Ltd Grow Up Japan INC.
HOMEbAbout Grow Up JapanbCONTACTbRESELLER

SMART DRIVE installation manual
Simple procedure to install a HDD into SMART DRIVE. Even bigginers can easily.
After the installation, just amount to 5h Inside-Bay of PC Enclosure as you do for DVD etc.
contents
1. SMART DRIVE
2. Cables ( for SATA HDD & for ATA Powe )
3. Screw ( for install to PC CASE )		 contentscontentscontents

Installation

step 1
Take the 6 screws out from the bottom side to remove the top-cover
and open it.

step 1
step 5
Suppress the top-cover strong and tighten the 6 screws.

step 4
step 2
Take the contents (cables) out from the Enclosure.

step 2
step 3
Make sure the cables are all the way seated properly.

step 3
step 6
Perfect. Then mount SMART DRIVE to the 5.25h bay of the PC with attached screws.

step 5
step 4
Put your HDD into SMART DRIVE properly. Then you will see that the connectors are pressing SMART DRIVEfs shock-absorber as on the picture gstep 6h, but it is correct.
 


Copyright(C) 2003 Grow Up Japan Co.,Ltd. All Right Reserved.